Hospital Electric Bed- Hospital Bed

Hospital Electric Bed- Hospital Bed
1.40×80 extra size beam, solid and durable
Specifications:
(1) Outline demensions
a.Length 2110mm ±3%
b.Width 980 mm ±3%
c.Bed height 430-700mm±3%
d.Back-rest lifting angle ranges 85 degrees. Knee-rest lifting angle ranges 40 degrees.

(2) Head/Foot board
a.Head/foot boards are integrated and made of ABS plastic steel.
b.Impact resistant, splinter proof, good looking; wood texture surface and impact proof pad on four sides

(3) Panel
a.Panel is ABS three-dimensionally formed with 3.5mm thickness, or steel monocoque.
b.Each panel has restraint strap hole and staggered large venting holes design, impact resistant, water resistant and washable.

(4) Bed body
a.The body is made of steel with powder coated, and the main beam of both sides use 40*80mm rectangular cold rolling steel tube.
b.At least six holes for containing drip pole and three transfer bag hangers.

(5) Guard rail
a.The tumbler switch of aluminum or plastic steel guard rail is mounted with wood texture profile.
b.Middle support use stainless steel and main support use solid iron rod with durable and snap proof design.

(6) Actuator system
a.Three sets of actuators, respectively control the body, back-rest and knee-rest. The actuator has thrust 4000N.
b.The controller is embedded in guard rails, inner and exterior controllable.
c.With water resistant, over load protective functions, ultra silence and three year warranty.
d.With power storage function, input voltage AC 110V±5% 60HZ, output voltage DC 24V, total working
current 8A, continuous usage for 10 minutes per hour.
e.The controller is embedded in guard rails, inner and exterior controllable.

(7) Standard configure
a.A four inlet and 2 nodes drip pole
b.A stretchable dinning plate
c.A set of embedded guard rail
d.5” anti dust caster with brake